Product

Kodak Magnus 800 platesetter

Background

This procedure describes how to use Service Shell to to save and restore the Magnus 800 operational parameters.
The parameters you back up with this tool are those stored on the workstation by the device control software (such as Magnus Controller, and Service Shell) and those on the device by firmware (such as the MCE and thermal imaging heads).

Procedure

1. Quit Kodak Magnus Controller.
2. Open Service Shell, and perform the following actions:
   Important: The Magnus Controller database must be manually restored in software version 1.02.402 of Magnus Controller.
   
   
   
   Note:
   • The backed up files are saved in the BART folder (C:\Creo\BART).
   • BART fails to restore the thermal head NVS file.
   • The files are automatically named according to the date and time they were created. For example, a file named 20060926_150733, was created on September 26th 2006 at 15.07 and 33 seconds.

See also

• How to restore the previously saved parameters onto the TMCE board
• How to load firmware onto the TMCE board

Technical contact(s)

Content owner: Nir Peleg
See the Escalation page for escalation contacts.

Date submitted

26 Sep 2006