Adjusting the Separator In/Separator Out actuators

Adjusting the separator in/out actuator regulators


Product		Trendsetter^® NEWS™ (full format NEWS device only) Trendsetter Autoloader

		WARNING: Failure to follow Kodak’s safety policies and procedures for field engineers may create a dangerous situation that could result in serious injury as well as damage to the output device. For more information, see the Safety page.

Procedure		There are four regulators controlling the speed of the separator in/out actuators—a pair on the away side of the picker (shown) and a pair on the home side.

		To adjust the regulators on the separator in/out actuators: Rotate the regulators with the red tubing to adjust `separator out` timing Rotate the regulators with the black tubing to adjust `separator in`timing Enter the `picker time` command and compare the times reported with the table in the Measuring engine, picker, and table actuator times and adjusting actuators document. If necessary, readjust the regulators and try again.

Test		After making adjustments to regulators controlling the speed of the separator in/out actuators, enter the `engine time` command and compare the times reported with the table in the Measuring engine, picker, and table actuator times and adjusting actuators document.

Technical contact(s)		Content owner: Frank van Eerdt See the Escalation page for escalation contacts. Trendsetter Autoloader Trendsetter NEWS
Date submitted		09 Jun 2004