It is very important that the picker be in the exact center of the load table (within
2mm), otherwise it will catch on the side post covers. Adjust the rails from side-to-side
until you can see the same amount of slot showing under the top M5 screw head and washer.
The picker head should have 1mm of side-to-side play in the rails.
Loosen the bottom of one of the rails. You are about to move the picker down so you want
to be sure that the rails are not angled towards each other causing the picker to bind.
Move the picker down by pressing on the blue button on the picker move solenoid.
Adjust the bottom of the rails so that the M5 screws and washers are in equal positions
in the rail slots and there is still 1mm of side-to-side play in the picker. Move the
picker up and again check the side-to-side play.
