Installation

For configuration and upgrade procedures, see the Procedures page.

Note: After every installation, open the Output Devices Installation Report Tool and submit the Installation Report. For instructions, see Using the Output Devices Installation Report Tool. Install the Trendsetter Installation Report Tool on the device workstation if necessary.

Acceptance

• Flexcel NX Digital Flexographic System Installation Test Procedure Checklist

• Trendsetter NX Test Files

Installation procedures

• Trendsetter NX Narrow/Mid Installation Procedure
• Flexcel NX Laminator Installation Guide

See also

• Trendsetter 400/800 Installation
  This link goes to the Trendsetter 400/800 site.
• Thermal 2 Head Installation
  This link goes to the Thermal 2 Head site.
• Flexcel NX Installation
  This link goes to the Flexo Media page.
• UDRC Installation
  This link goes to the UDRC site.

Site preparation

• Flexcel NX Digital Flexographic System Site Preparation Guide

How to complete the site inspection checklist contained in the above PDF document:

1. Click in text fields to enter comments and click on check boxes to select them, and then print a hard copy for the customer to sign.
   OR
   Print a hard copy first, and mark the information by hand.
2. Go over the checklist with the customer and get his or her signature on the hard copy.
3. Photocopy the signed checklist and leave the copy with the customer.
4. Send the original signed copy to Sales Order Management at the address shown in the checklist.


• Site Preparation for the Universal Debris Removal Cabinet



• Air Compressors for Kodak Output Devices
• On-Site Compressed Air Qualification for Creo Output Devices 73-3624