Connectivity

• Trendsetter Connectivity site
  Includes status information on all workflows/RIP software, relevant documentation, contact information, and procedural information (where applicable).
• Print Console Overview page
  Lists all released Print Console versions.

Platesetter Console

Usually, Prinergy 2.0 connects to output devices via Print Console 2.0. However, Print Console cannot drive devices that use Green heads. To connect Prinergy 2.0 to an output device that uses a Green head, Platesetter Console 2.0 must be used as the device control software. This means that Prinergy 2.0 connects to the device via a direct connection with the Creo Recorder Interface (CRI) within Platesetter Console.

• For general Platesetter Console information, see the Allegro Workstation Software 2.0 home page.
• Installing Platesetter Console 2.0 with Prinergy 2.0 (211 KB)

Platforms

Print Console 2.x does not support Alpha. It supports Intel platforms only.

• Print Console Hardware Overview
  Document describes server options (Dell 2500L, Dell 2500H, Dell 2400L, Dell 2400H, or Optiplex) for Print Console.
• Intel platform pages: Dell platforms, DG/EMC platforms

Output Devices

General:

Print Console 2.0 supports almost all Creo output devices, not including ex-Scitex devices and devices with Green heads. Some devices, such as the the TS 2637, TS400, VLF TS AL, Platesetter 3244, Platesetter VLF, and ThermoFlex, remain in Beta pending approval.

• Refer to the Trendsetter Connectivity Site page.

Platesetters:

• A kit containing the CD, floppy disk and installation procedure for Platesetter Console 2.0 is available: 20-0093A S/W KIT,PCS/TCS 2.0 FOR CRI (GREENHEAD)