| Variables | actuator mode | Specifies the auto-focus system actuator mode. |
| Description | This command sets the actuator mode of the auto-focus system. The following are valid actuator modes: | |
| Actuator Mode 0 ('current' mode): In actuator mode 0 the input to the actuator is considered to be the electrical current flowing into the coil. | ||
| Actuator Mode 1 ('force' mode): In actuator mode 1 the input to the actuator is considered to be the force exerted by the magnetic coil. | ||
| Related Documents |
PARAMETER: foc fca1 | |
|
PARAMETER: foc fca2 | ||
|
PARAMETER: foc fca3 | ||
|
PARAMETER: foc fca4 | ||
|
PARAMETER: foc fck1 | ||
|
PARAMETER: foc fck2 | ||
|
PARAMETER: foc fcki | ||
|
PARAMETER: foc actmode | ||
| Firmware Notes | Actuator mode 0 is the normal operating mode which has been used since the beginning of TH2. Actuator mode 1 was developed to increase the servo performance. | |