|
|
|
|
| offset
| Specifies the first spot to control from 0 to 463.
|
|
| width
| Specifies the number of spots to control from 1 to 464.
|
Set the spot state for the specified range of spots. The spot state, configurable for individual spots, will be one of the following:
|
|
|
|
|
| The spot state configuration can be updated as required, but only takes affect for the "Local" light valve control modes.
|
|
| The NVS parameters med <media index> strokeoffset and med <media index> strokewidth configure the stroke. Note that the configured stroke does not affect the spot offset.
|
Thermal 1.0 / 1.7x equivalents:
|
|
|
- The monitor command lvd (<offset> <width>|all) (off|on) replaces spot <index> <width>, spot full and spot off.
- Thermal 1.0 / 1.7x is limited to 240 pixels.
- Thermal 1.0 / 1.7x is limited to turning one, two or four pixels on at any time with all remaining pixels off.
|
|
| Thermal 2 equivalents:
|
|
|
- The monitor command lvd (<offset> <width>|all) (off|on) is equivalent to lvd (<offset> <width>|all) (off|on).
- Thermal 2 is limited to 240 pixels.
|
COMMAND: lvd (<offset> <width>|all)
|
|
|
COMMAND: lvd pattern <nibbles>
|
|
|
PARAMETER: med <media index> strokeoffset
|
|
|
PARAMETER: med <media index> strokewidth
|
|
|
ERRORCODE: [05807] The spot index is invalid
|
|
|
ERRORCODE: [05808] The spot state is invalid
|