Thermal 3 Errorcode: [05638] The write laser control mode has been aborted


Service Information	The commands implemented by the exposure head are non-blocking. As a result, the command to configure the write laser control mode will only initiate the write laser control mode. This error code indicates that configuration of the write laser control mode has been aborted.
	Note that the command to configure the write laser control mode can be aborted when requested by the host ( or user ) or when required by the fault handler.
Operator Action	None, this is an informational message only.
Causes	The write laser control mode has been aborted.
Related Documents	COMMAND: sys plot (init\|start\|pause\|restart\|stop\|abort)
	COMMAND: sys laser state
	COMMAND: sys laser [on\|standby\|off\|anneal]