Description:

This command is only for use with a TFX head. Before entering this command the stage should have been sent to the away position using the stage install command to update the hsap parameter. Once the hsap parameter is valid and a TFX head is installed in the machine switch to a media setup for the drum (usually 7 or 8) using the mode media command. Now enter the stage install tfx command (NOTE: This command needs to be run after installing a TFX head and only needs to be run once).

This command will actually do the equivalent to a stage zero command exept trying to focus on the drum instead of a piece of media. Once focussed on the drum the firmware will automatically update the al dfp (drum focus position) parameter which is used in all stage zero commands when a TFX head is installed.

Notes:

None.

Applies To:

• ThermoFlex

Syntax:

See Also:

• Command: stage
• Command: stage moveto
• Command: stage stop
• Command: stage init
• Command: stage install
• Command: stage getfocus
• Command: stage zero
• Command: stage home
• NVS: al hsap
• NVS: al dfp
• Command: mode media