Dolev 800 - Loading/Unloading System -
Loading System Assembly

Rubber Roller (Driver) Chain (medium)

Loading System - Type I (zoom image)
Loading System - Type II (zoom image)

Description
Replacement
Check

Description

The chain drives the two medium rubber rollers (A70 and A35). The rubber
rollers load the film from the loading cassette into the pressure rollers.

Replacement

Tools, Accessories and Jigs
Removing the Old Assembly
Assembling the New Chain

Tools, Accessories and Jigs

jig 280A34180
jig 280A34180 - a
jig 280A34180 - b

Flat screwdriver
Phillips screwdriver
Allen keys
Rubber roller service tool (280A34180)

Removing the Old Assembly

Note: The orientation of the illustration is from the back side of the assembly.

1. Remove the loading/unloading system.
   
   
2. Remove the Left Back light cover (#132).
   
   
3. Remove the lower medium light cover (#126).
   
   
4. Disassemble the cassette motor (#70).
   
   Remove three 8-32 x 5/8 screws and washers (#14,6,23).
   
   
5. Pull the motor forward to free the chain from the motor sprocket. The motor wiring is still attached to the motor: Be careful not to displace the wires.
   
   
6. Disassemble the upper lever (#5,6,23,39).
   
   
7. Free the washers, E-rings and spring. Place the loading system on its side.
   
   
8. Insert the rubber roller service tool (280A34180) into the driving shaft (#41). Gather all of the Dellerin washers.
   
   
9. Remove the rubber roller (#54).
   
   
10. Remove the chain (#29).

Assembling the New Chain

1. Insert the new chain (#29).
   
   
2. Put back the rubber roller (#54).
   
   
3. Insert the rubber roller service tool (280A34180) into the shaft (#41). Put each of the Dellerin washers on the roller, in the correct order.
   
   
4. Put back the washers, E-rings and spring. Place the loading system right side up.
   
   
5. Re-assemble the upper lever (#6,5,23,39).
   
   
6. Insert the motor with the axis slightly forward. Place the chain on the motor sprocket. Push the motor into position with the chain tension set.
   
   
7. Re-assemble the cassette motor (#70).
   
   Tighten three 8-32 x 5/8 screws and washers (#14,6,23).
   
   
8. Check that the chain path is parallel to the right side plate (#9). This indicates alignment between the motor sprocket and the drive rollers.
   
   
9. Put back the lower medium light cover (#126).
   
   
10. Put back the Left Back light cover (#132).
    
    
11. Replace the loading/unloading system.

Check

Enter the diagnostics program.
Select UTILITIES. Select MECHANICS.
Select 4. Cassette from the Mechanics Menu.
Replace the loading/unloading system.
Mechanics Menu

1. Run the medium cassette forward and backward:
   Forward Cass.
   Reverse Cass.
   Stop Cass.
   
   
2. When the unit completes the check, assemble the loading and unloading system onto the Imagesetter.
   
   
3. Perform five (5) minimum length film feeds from the medium cassette. Measure the film. It must match the film length you entered.