Troubleshooting - VLF Trendsetter AL Picker Actuators Do Not Reset

Applies to	VLF Trendsetter AL

Machines affected	All machines.

Error Number	None

Component	Picker

Problem	The picker doesn't power up because its actuators haven't reset.

Causes and Solutions	Cause 1: Wrong signal received from firmware Solution: Check that the firmware is sending the correct reset signal. Cause 2: Genine 2 board or driver has failed Solution: See VLF Trendsetter AL Genine boards. Cause 3: P-cup home sensor has failed. Solution: Cause 4: Unload finger home sensor has failed. Solution:Replace the unload finger home sensor. See VLF Trendsetter AL Sensors and Switches. Cause 5: Solenoid/valve has failed. Solution: Replace the solenoid. Cause 6: Connections are faulty. Solution: Check for poor connections or faulty wiring between: Genine 2 board and the power box solenoid and Genine 2 board Cause 7: Air supply is inadequate. Solution: See Diagnosing the air supply.

Causes and Solutions

Cause 1: Wrong signal received from firmware
Solution: Check that the firmware is sending the correct reset signal.

Cause 2: Genine 2 board or driver has failed
Solution: See VLF Trendsetter AL Genine boards.

Cause 3: P-cup home sensor has failed.
Solution:

Cause 4: Unload finger home sensor has failed.
Solution:Replace the unload finger home sensor. See VLF Trendsetter AL Sensors and Switches.

Cause 5: Solenoid/valve has failed.
Solution: Replace the solenoid.

Cause 6: Connections are faulty.
Solution: Check for poor connections or faulty wiring between:

Cause 7: Air supply is inadequate.
Solution: See Diagnosing the air supply.

Picker actuators don't reset