Home | Contact Us | Submit Troubleshooting Info | Search | Help


    Output | Software Solutions | Proofing | Color, Screening and Calibration | Scanning | Digital Photography | Consumables | POS

Thermal 2 Errorcode: [03544] The write laser control mode has been aborted

Error details | Troubleshooting information

Thermal2 Errorcode: [03544] The write laser control mode has been aborted
Thermal2 Errorcode
[03544] The write laser control mode has been aborted

Service Information The commands implemented by the exposure head are non-blocking. As a result, the command to configure the write laser control mode will only initiate the write laser control mode. This error code indicates that configuration of the write laser control mode has been aborted.

Note that the command to configure the write laser control mode can be aborted when requested by the host ( or user ) or when required by the fault handler.

Operator Action None, this is an informational message only.

Causes
  • The write laser control mode has been aborted.

Related Documents COMMAND: sys plot (init|start|pause|restart|stop|abort)
COMMAND: sys laser state
COMMAND: sys laser [on|off]

Applies to: THERMAL2
Modified: Fri Apr 20 13:24:45 2007
Updated: Thu Jul 17 02:31:36 2008
Module: SYS

Troubleshooting information

Possible cause

  

This is a general message indicating that the head could not turn on the laser.

  1. Check that the LVD parameter hvtrim has the correct value (refer to the related procedure).
  2. Check for other error messages.

Suggested action

  
  • Stroke cal fails and hvtrim has a value of 0
    English | Invalid Key | Invalid Key
  • To find other error messages, enable verbose for LDD, BPD, and BBS. This will help you find out more specific information about the problem.

Related Procedure(s)

  

 

    Copyright © 2005 Creo Inc. All rights reserved. Confidential. Back to top.