Thermal3 Command: sat dw (lvdp|lvdn) <board> [<register-hex> [<length>]]


Variables	board	The lvd board number from 0 to 7.
	register-hex	The first register to display ( in hexadecimal ).
	length	The number of registers to display.
Description	This monitor command is intended only for development purposes. It allows the display of lvd satellite board registers with several display options designed to aid in scripting versatility. Every lvd satellite board implements 32 16-bit registers mapped to main memory. These main memory locations are refreshed with serial data transfers from specified satellite boards before being displayed by the monitor command. Since most satellite registers fulfill specific requirements for each satellite board, the user of this monitor command must have intimate knowledge of the specified satellite to make much use of the displayed register values.
Notes	Thermal 1.0 / 1.7x equivalents:
	The monitor command sat dw (lvdp\|lvdn) <board> [<register-hex> [<length>]] does not have an equivalent.
	Thermal 2 equivalents:
	The monitor command sat dw (lvdp\|lvdn) <board> [<register-hex> [<length>]] does not have an equivalent.
Related Documents	COMMAND: sat ver
	COMMAND: sat (install\|uninstall) [<satellite>]
	COMMAND: sat uninstall all
	COMMAND: sat dw <satellite> [<register-hex> [<length>]]
	COMMAND: sat ww <satellite> <register-hex> <value-hex>
	COMMAND: sat ww (lvdp\|lvdn) <board> <register-hex> <value-hex>
Firmware Notes	This command was added in firmware version 1.05