|
|
|
|
| board
| The lvd satellite board number from 0 to 7.
|
|
| register-hex
| The register to write ( in hexadecimal ).
|
|
| value-hex
| The value to write ( in hexadecimal ).
|
This monitor command is intended only for development purposes. Every lvd satellite board implements 32 16-bit registers mapped to main memory. This monitor command allows users to write 16-bit hexadecimal values to specific lvd satellite board registers.
|
|
| After a new register value is written to a main memory location the associated satellite register is automatically refreshed via serial data transfer to the satellite board. Since most satellite registers fulfill specific requirements for each satellite board, the user must have intimate knowledge of the specified satellite to make proper use of this monitor command. )*** Command Success ***
|
Thermal 1.0 / 1.7x equivalents:
|
|
|
- The monitor command sat ww (lvdp|lvdn) <board> <register-hex> <value-hex> does not have an equivalent.
|
|
| Thermal 2 equivalents:
|
|
|
- The monitor command sat ww (lvdp|lvdn) <board> <register-hex> <value-hex> does not have an equivalent.
|
COMMAND: sat ver
|
|
|
COMMAND: sat (install|uninstall) [<satellite>]
|
|
|
COMMAND: sat uninstall all
|
|
|
COMMAND: sat dw <satellite> [<register-hex> [<length>]]
|
|
|
COMMAND: sat dw (lvdp|lvdn) <board> [<register-hex> [<length>]]
|
|
|
COMMAND: sat ww <satellite> <register-hex> <value-hex>
|
This command was added in firmware version 1.05
|