Thermal 3 Errorcode: [08007] The stepper driver is active


Service Information	The monitor commands act initialize, act shutter (open\|close) and act actuate <index> <steps> will wait a maximum of thirty seconds for the actuation of the stepper driver to complete. This error code indicates that the previous actuation of the stepper driver is not complete.
Operator Action	Call service.
Causes	The maximum acceleration and / or the maximum speed is too low. Hardware failure of the stepper driver.
Related Documents	COMMAND: act initialize
	COMMAND: act shutter (open\|close)
	COMMAND: act actuate <index> <steps>
	PARAMETER: act shutteracceleration
	PARAMETER: act shutterspeed
	PARAMETER: act blockeracceleration <index>
	PARAMETER: act blockerspeed <index>