| Description | Determine the fault state. System faults will monitor the state of the system and if required, abort plots in progress or block the launching of plots. System faults only represent a fraction of the fault conditions that the exposure head will detect. However, other fault conditions can only be detected while a plot is in progress. | |
| Note that the monitor command adc will display the health metrics and the monitor command hlt mask (on|off) <index> will configure the fault mask's while the monitor command sat status will display the satellite faults and the monitor command sat mask (on|off) <index> will configure the fault mask's. | ||
| Notes | Thermal 1.0 / 1.7x equivalents: | |
| ||
| Thermal 2 equivalents: | ||
| ||
| Related Documents |
COMMAND: sys fault (warning|shutdown|fatal reset|fatal disable) [<number>] | |
|
COMMAND: adc [(hc|npe|act|pbp|ibs|dbp|wlc|rfe|lvdu|lvdl|pbp2|lvdp|lvdn)] | ||
|
COMMAND: hlt mask [(on|off) <index>] | ||
|
COMMAND: sat status | ||
|
COMMAND: sat mask [(on|off) <index>] | ||
|
ERRORCODE: [05652] Satellite fault(s) have been detected | ||
|
ERRORCODE: [05650] Health metric(s) have faulted | ||
| Firmware Notes | The monitor command sys fault state corresponds to the API function CEH_FaultState( ) in the CEH API document. | |