Thermal 3 Errorcode: [05204] The command setpoint is invalid


Service Information	The monitor commands ldd cal (dual\|a\|b) <setpoint>, ldd on (dual\|a\|b) <setpoint>, ldd on man (dual\|a\|b) <setpoint>, ldd current (dual\|a\|b) <setpoint>, ldd man (dual\|a\|b) <setpoint>, ldd hold and ldd off will set the laser diode control mode. This error indicates that the setpoint is invalid.
Operator Action	Verify the previous monitor command and enter a valid setpoint.
Causes	The setpoint is invalid.
Related Documents	COMMAND: ldd cal (dual\|a\|b) <setpoint>
	COMMAND: ldd on (dual\|a\|b) <setpoint>
	COMMAND: ldd on man (dual\|a\|b) <setpoint>
	COMMAND: ldd current (dual\|a\|b) <setpoint>
	COMMAND: ldd man (dual\|a\|b) <setpoint>