Site Preparation is on the Installation page.
Documentation is on the Reference page.
Training is on the Reference page.
Release Notes are on the Reference page.
Assemblies are on the Drawings/photos page.
Maintenance is on the Procedures page.
Technical Notes are on the Troubleshooting page.
Parts are on the Parts/tools page.
Software is on the Downloads page.

The Lotem 400 FH, Magnus 400 LDA, and Magnus 400 II LDA calibration test procedures have been updated and are available for reference purposes. A short overview, including anti-collision guidelines, is also available.
Go to Calibration tests under Calibration on the Procedures page.

FCO 512-00441A for Xpo 3.1.42 corrects the problem where the Xpo software stops responding after platesetter failure and goes into a loop. Find this item on the FCOs page.

Note: It is recommended to install the update even if the problem did not occur.

During data transfer, the carriage repeatedly executes a stop spiral command. Find this item under expose on the Troubleshooting page.

FCO 512-00411A resolves the problem of roller marks that appear on the plates during the unload process. Find this item on the FCOs page. For more information, see Replacing the upper roller assembly with a one-piece upper roller on Magnus 400.

Attention: For platesetters released with serial number M41391 and earlier.

During the unload process, roller marks appear on the plates due to the design of the current upper roller assembly. To prevent roller marks, replace the upper roller assembly with a one-piece upper roller. Find the procedure under FCO procedures on the Procedures page.