Splot firmware is on the Lotem 800 II Splot Controls and Settings page.
Site Preparation is on the Installation page.
Specifications are on the Overview page.
Spare parts and jigs are on the Parts/tools page.
User guides are on the Reference page.

Go to the Safety page.

The original Lotem 800 II platesetter CPU can no longer be purchased. Therefore a replacement CPU kit had to be created. This procedure describes how to 21316. Go to Lotem 800 II part replacement procedures on the Procedures page.

If you try to connect a cable when the pins are not properly aligned, you may damage the connector and the pins. This can cause intermittent communication, lvd data, or safety loop errors.

The military connectors should sit easily and evenly. If this is not the case, do not force the connector.

Go to Always check the pin alignment before connecting the control cable. If you suspect that the pins are damaged, go to Intermittent communication, lvd data, or safety loop errors.

This troubleshooting document describes how to retract a cassette, located inside the Lotem 800 II platesetter, to the MCU user door. Go to Loading/Unloading on the Troubleshooting page.

This troubleshooting document describes how to resolve the issue whereby MCE boards are stuck in boot mode during the software upgrade. It also explains how to prevent the issue from reoccuring during future upgrades of the same software version. Go to Firmware on the Troubleshooting page.

This troubleshooting document describes how to resolve issues relating to the Brisque when upgrading the Lotem 800 Controller software. Find this item under Brisque on the Troubleshooting page.

This troubleshooting document describes how to diagnose problems with the USB port on a Lotem 800 II platesetter. Find this item under PC Problems on the Troubleshooting page.