Product

Kodak^® punch conveyor

Background

If the LED detector is faulty, or otherwise impaired, you need to replace it.

Requirements

Procedure

Note: During this procedure, you will be removing a number of screws. Make sure to save these screws for future installation purposes.

Removing the LED detector

1. Quit the Magnus 400 Controller software and turn off the platesetter.
2. Under the punch conveyor near the right front leg, disconnect the gray PLT DET Molex^® connector.
3. Under the punch conveyor near the middle of the front legs, remove the two screws that secure the LED detector (bracket) to the chassis, and remove the detector.
   
   
   

Installing the LED detector

1. Under the punch conveyor, insert the new LED detector (bracket) and secure it to the chassis with the two screws that you removed eariler.
2. Connect the gray PLT DET Molex connector to the punch conveyor harness.
3. Turn on the platesetter and start the Magnus 400 Controller software

Technical contact

Content owner: Alon Davidor
See the Escalation page for escalation contacts.

Date submitted

18 Feb 2008