Thermal Head 2.0 Installation

Steps 35-39: Check and Adjust Image Quality

Print version:  To print out the instructions below, click on the print icon at the top of the page.

35. Load a plate into the machine.
36. Perform a focus series to determine the best focus offset value.
37. Inspect the plate to make sure that the head is square to the drum.
38. Perform an exposure series to determine the correct wpower value.
39. Check and adjust bmslope and bmcurve.
40. Check the plate for banding.

For further information on image quality, see Media troubleshooting

• Steps 1-5: Prepare the Head
• Steps 6-10: Mount the Head
• Steps 11-14: Connect the Cables and Hoses
• Steps 35-39: Check and Adjust Image Quality