Trendsetter Autoloader GMCE/TMCE Assemblies

Serial numbers begin with TG (GMCE) or TM (TMCE)

Note: Check SAP for up-to-date information.

Assemblies, high level
Disassembly kits

Assemblies, high level
11-1111A Debris Removal Hooks kit, TSM BOM
11-1060A Autoloader final assembly kit, TSM
Drawing | BOM
11-1025A Autoloader/NEWS common electrical parts kit, TSM BOM
50-1538C Autoloader/NEWS common mechanical parts kit, TSM BOM
50-1714B Autoloader common mechanical parts kit, TSM BOM
11-0817B Non-rotator Autoloader kit, TSM BOM
11-0816B Rotator Autoloader kit, TSM BOM
500-00121 Autoloader manual load mainframe kit, TSM
Drawing | BOM

Engine

Engine, TSM—50-2439A
BOM

Carriage

Carriage motor and Pulley—11-1133
Drawing not available | BOM

Carriage Motor—184-00012
Pulley—57-2184

Carriage motor cooling assembly—11-0885
Drawing | BOM
(fan #10-4521A)

Autoloader assemblies

Load Ramp
50-1499B  BOM

Lower ramp cylinder, home 50-1653A Drawing|BOM
Upper ramp cylinder, home or away (FRU) 512-00263A - kit contains 2 cylinders plus all fittings Drawing - see FCO CA06235
Plate sensor 36-3210
Nylon spacers 52-3223 - 5 pieces home side, 6 pieces away side photo
Spacers should not be too tight—allow 1 mm of movement after spacers installed.

Load Table, TSM—50-1525E
Drawing | BOM

Bay door
Door lock solenoid—10-3739A
Door lock relay—10-3800B
Gas strut cylinder—330-00080 see CA04191
Plastic ball coupling for gas strut cylinder—368-00086
Gas strut ball stud—55-0199
Metallic clip that holds gas strut to ball mount—55-0202
Right hinge—59-3291
Left hinge—59-3292

Load table support bracket - 57-5450A

Operator door interlock assembly 50-1526 Drawing | BOM

Plate ledge assembly—50-2154
Drawing | BOM

Plate separator arms—see page 2 of 50-1525D Drawing and specific parts on 50-1525 BOM
Separator arm kit—50-2689A BOM
Separator cylinder—55-0574
Separator bracket—05-0076

Microswitch for plate separator arms— see page 2 of 50-1525D Drawing and see specific parts on 50-1525 BOM
Separator microswitch—15-3135
Separator microswitch bracket—57-4831B

Plate sensor—36-3210
Picker vacuum generator—340-00001
Order kit 518-00114A to replace failed vacuum generator (340-00001 or 55-0632) or muffler (55-0569).
Warning light bulbs—36-3156 (part of assy 10-3742A) (TM467 and lower)
Corner lights—10-3741A Drawing (TM467 and lower)

Manifold 50-1720B Drawing | BOM

Valve, Single Solenoid—55-0771
Valve, Double Solenoid—55-0954

Operator Door and Skins

Operator Door—50-1992A Drawing | BOM
Lower Operator Door (purple)—50-1931C Drawing
Lower Operator Door (white-gray)—50-1931B
Panel Kit TS8 AL—50-1973A BOM

Picker, Version III, TSM
50-1759B
Drawing | BOM

Picker Head Assembly
50-1760 Drawing | BOM

Mylar replacement strip, 57-6640A or 252-08408A for Fuji LH-PI
Picker head in/out cylinder kit 518-01238A - includes 2 cylinders and 2 elbows
cylinders on both sides should be replaced
Picker wrist cylinder 330-00002 see FCO CA00567 Wrist Cylinder Upgrade
Suction cups W\O valve, silicone, red 55-0706
Vacuum Generator 340-00001
Order kit 518-00114A to replace failed vacuum generator (340-00001 or 55-0632) or muffler (55-0569).
Wrist sensor cable assembly 10-4579A

Picker move up/down cylinders
Right 50-1761A Drawing | BOM
Left 50-1762A Drawing | BOM
   55-0804 (cylinder only)
Picker move sensor cable assembly 10-4071A (on Load table BOM)

Picker rails
Right 50-1763B Drawing | BOM
Left 50-1764C Drawing | BOM

Picker up/down sensors cable assembly 10-4651A Drawing
Optical sensors on rails - order kit 518-01911A (FCO CA10840) to replace 10-3676A
Picker rail bottom bracket 57-6000A (item 30 on 50-1763B and 50-1764C drawings)

Picker guide cable (Stainless steel) 50-1765A

Lower pulley for guide cable (Picker 3) 57-6015A Drawing
Pulley 1, Move Cylinder (Larger upper pulley for Picker 3) 57-6016A Drawing
Pulley 2, Move Cylinder (Small upper pulley for Picker 3) 57-6017A Drawing
Bushing,1/4"*5/16"*1/2",Bronze 54-4024

Miscellaneous
Speed ctrl 0.1mm orfice 55-0807
Speed ctrl 0.2mm orfice 55-0806

Sensor reed switch 15-3063
Magnet for reed switch 59-3141

Unload Pans

  Non-rotator

Short pan (non-rotator)—50-2427B
Drawing | BOM

Traveler—50-2428
Drawing | BOM

Motor/drive pulley assembly—50-1496B BOM
        Motor assembly kit – 512-00256A Drawing | BOM (this kit to be ordered by field service engineer)
                Motor only—15-3234 (FYI only)
                Drive pulley—50-1756B (see FCO CA02183)
                Rubber spider in coupling between pulley and motor—50-0231
Plate eject sensor—36-3210
Suction Cup—55-0541
Traveler home/away optical sensor—10-3683

Short bridge—50-1617A
Drawing | BOM

Unload table replacement pans
Center panel—57-4870A
Left panel—57-7322A
Right panel—57-7321A

  Rotator

Long pan (rotator) 50-1492B Drawing | BOM
In addition to the parts listed under non-rotator:

Rotating traveler 50-1458A - includes cable track
Drawing | BOM

Flex track 10-3678D E876
Suction cup up/down cylinder 55-0257
Suction cups 55-0541
Rotate cylinder 55-0619
Traveler rotate magnet 59-3141
Traveler rotate sensor 15-3063

Long Bridge—50-1456B Drawing | BOM

Unload table pan replacement kit—50-2452A - includes the 3 top panels for the unload pan and the 2 panels to the right and left of the unload pan but does not include bridge panels

Unload Table 50-1449B
Drawing | BOM

Lexan side panels (non-rotator) 500-01928A Drawing
OR
Lexan side panels (rotator) 500-01927A Drawing

Rear cover panel 50-1535A Assembly Drawing

Unload cylinder 50-1493A Assembly Drawing |BOM

• Cylinder only 55-0604
• Orifice for non-rotator table 55-1188 Drawing item 20
• Orifice for rotator table 55-1187 Drawing item 20

Clevis and Pin Kit 50-2341A FCO E100
Kit includes:

• 52-4488 Cotter pin, auto locking, 1/2" shaft (2)
• 52-4064 M12 washer (4)
• 52-4897 Clevis pin, 7/16"*2.5" (2)
• 55-0605 Rod end, clevis, 5/8" - 18, 0.43 Pin (2)

Plate pusher—50-1690
Drawing |BOM

Safety guard—57-5245

Disassembly kits

Autoloader common disassembly kit(TSM)—518-00128 BOM
Autoloader/Spectrum disassembly kit—518-00650 BOM
Common boxed parts disassembly kit—50-1923 BOM
Trendsetter Base disassembly kit—50-2287 BOM
Common add-on parts disassembly kit—50-2323 BOM