Procedures

These procedures are to adjust, align, replace, or upgrade existing Autoloader assemblies.

For installation procedures, see the Installation page.
For maintenance procedures, see the Maintenance page.

Adjustment/alignment | Disassembly | Upgrades

Base Trendsetter 400/800 Procedures

Adjustment/alignment

General
Leveling procedure

Load Ramp/Table
Plate Loading Position Guide for Trendsetter 400/800 III
Alignment Label Placement
Film guide adjustments
Plate measuring sensor offset setting
Replacing the Load Ramp Sensor
LEC firmware position for loading and unloading

Unload Table
Adjusting the unload table plate-eject settings
Calibrating the unload table cup rotate position
Unload Table Height Adjustment
Measuring engine, picker, and table actuator times and adjusting actuators

• Adjusting the table rotate on/off actuator regulators

Disassembly

• Trendsetter Disassembly Procedure
  Disassembly Kits

Upgrades

• Outrigger upgrade procedure for rotator unload table
• Trendsetter 400/800 II ContinuousLoad Field Upgrade Procedure
• Trendsetter II CL to AL upgrade procedure