Procedures

These procedures are to adjust or align existing assemblies.
For installation procedures, see the Installation Page.
For procedures for the base Trendsetter VLF, see the Trendsetter VLF Procedures page.
For maintenance procedures and information on ordering consumables, see the Maintenance Page.
For upgrade procedures, see the Upgrades Page.

Adjustment/alignment | Calibration | Debris removal | Disassembly | Other procedures

Adjustment/alignment

• Alignment Checklist
• Alignment verification tools - Kit 50-2437

Air Supply

• Installing the Rx Air Pressure Sensor
• On-Site Compressed Air Qualification for Creo Output Devices 73-3624  

Multiple Cassette Unit (MCU)

• Measuring the MCU Jackscrew Nut Backlash
• Removing MCU Panels  
• Assembling MCU Skins

Picker

• Delicate Media Picker Roll Bar Home and Away Sensor Adjustment
• Wedgemaster Upgrade Procedure
• Setting the Slipsheet Threshold  

Single Cassette Unit (SCU)

• Replacing the Garage Plenum  

Slip Sheet Removal (SSR)

• Slip Sheet Removal Procedures

Trendsetter

• Calibrating Pressure Sensors  
• Assembling the Floor Plate  
• Dehumidifier Unit (DHU) Installation Procedure  
• On-Site Compressed Air Qualification for Creo Output Devices 73-3624
• Checking the Air Supply without a Test Gauge

Calibration

• Calibrating Pressure Sensors  
• Programming the Table Bottom Slipsheet Sensor  
• Calibrating the SSR Motor Drive Unit

Debris removal

• Debris Removal System Procedures

Disassembly

• Trendsetter VLF AL Field Disassembly Procedure 725-00004A 
• Trendsetter VLF AL Field Crating Procedure 725-00005A 
• Disassembly Checklist 73-7308
• Parts-Tools Page for Disassembly Kit

Other procedures

• Firmware Upgrades: Backing up and restoring MCE, MPE, PDB, LIONEL, and GENINE boards