Thermal 3 Errorcode: [05202] The control mode is invalid


Service Information	The monitor commands ldd cal (dual\|a\|b) <setpoint>, ldd on (dual\|a\|b) <setpoint>, ldd on man (dual\|a\|b) <setpoint>, ldd current (dual\|a\|b) <setpoint>, ldd man (dual\|a\|b) <setpoint>, ldd hold and ldd off will set the laser diode control mode. This error indicates that the laser diode control mode is invalid.
Operator Action	Call service.
Causes	Firmware error that will occur during firmware development and testing.
Related Documents	COMMAND: ldd cal (dual\|a\|b) <setpoint>
	COMMAND: ldd on (dual\|a\|b) <setpoint>
	COMMAND: ldd on man (dual\|a\|b) <setpoint>
	COMMAND: ldd current (dual\|a\|b) <setpoint>
	COMMAND: ldd man (dual\|a\|b) <setpoint>
	COMMAND: ldd hold
	COMMAND: ldd off