| Description | Determine the fault state. System faults will monitor the state of the system and if required, abort plots in progress or block the launching of plots. System faults only represent a fraction of the fault conditions that the exposure head will detect. However, other fault conditions can only be detected while a plot is in progress. | |
| The system faults that will abort plots in progress or block the launching of plots are as follows: | ||
| ||
| Note that the monitor command sys fault will display the fault configuration and the monitor command sys fault <point> (on|off) will configure the fault mask's. | ||
| Notes | Thermal 1.0 / 1.7x equivalents: | |
| ||
| Related Documents |
COMMAND: sys fault (warning|shutdown|fatal) [<number>] | |
|
COMMAND: sys fault [<point> (on|off)] | ||
|
ERRORCODE: [03553] A safety loop fault has been detected | ||
|
ERRORCODE: [03554] The control board temperature is out-of-range | ||
|
ERRORCODE: [03555] The focus driver temperature is out-of-range | ||
|
ERRORCODE: [03556] The +5V is out-of-range | ||
|
ERRORCODE: [03557] The +3.3V is out-of-range | ||
|
ERRORCODE: [03558] The -5V is out-of-range | ||
|
ERRORCODE: [03559] The +40V is out-of-range | ||
|
ERRORCODE: [03560] The +15V is out-of-range | ||
|
ERRORCODE: [03561] The data cable (hotlink/coax cable) is not detected | ||
|
ERRORCODE: [03562] The stroke clock is not detected | ||
| Firmware Notes | The monitor command sys fault state corresponds to the API function CEH_FaultState( ) in the CEH API document. | |