Site Preparation is on the Installation page.
Documentation is on the Reference page.
Firmware is on the Control/settings page.
Software is on the Downloads page.

Update 5 is available for the Lotem 400 Controller version 1.50.08 software.
Go to the Downloads page.

Update 5 supports improved paper-picking and paper disposal parameters.
Go to the Reference page.

Each time that you replace a thermal imaging head, you must fill out the Exposure head request (EHR) form and notify all members on the #CEM-EH Request list.
For more information about returning thermal heads, see Replacing a thermal head.
Go to the Parts/tools page.

When the drum stops frequently rotating and vibration error messages appear, you need to adjust the position of the drum vibration sensors.
Go to the Procedures page.

The image between the plates will not be correctly registered if the plate height is not exactly the size it is supposed to be when using the image-to-edge edge detection system. To avoid this problem, cancel edge detection and perform image exposure according to image-to-punch, as described in “ Installing the center punch on Lotem 400 and Magnus 400 ”. Find this procedure under Parts replacement on the Procedures page.

If your platesetter has a problem with the dongle, you need to reset the platesetter. Find this item under error-system messages on the Troubleshooting page.

FCO 512-00411A resolves the problem of roller marks that appear on the plates during the unload process. Find this item on the FCOs page. For more information, see Replacing the upper roller assembly with a one-piece upper roller on Magnus 400.

Attention: For platesetters released with serial number M41391 and earlier.

During the unload process, roller marks appear on the plates due to the design of the current upper roller assembly. To prevent roller marks, replace the upper roller assembly with a one-piece upper roller. Find the procedure under FCO procedures on the Procedures page.