Troubleshooting

Choose a keyword to go to troubleshooting or other technical information associated with it.

Artifacts

• Artifact gallery
• Cloud or blotch-shaped artifacts appear in solids

Autofocus

• Autofocus tracking error with artifacts

Edge detection

• Edge detect problems when running TH3_plot_series.spt
• Edge detect problems after a TH2 to TH3 conversion

Error/system messages

• [01403] Failure verifying the BSDL data / JTAG error(s)
• TH3 resets when door unlock command is issued on a Magnus VLF. See Magnus VLF CR4.01 patch 5.
• Laser diode failure [error 05208] or invalid beam-pointing signal level [error 04413]
• GMCE error 45242: Warning [Product1:Chiller flow is too low (Chiller flow sensor)]
• New TH3 error codes, field access
• Changes in error codes, TH2 to TH3, field access

Updated 29 Mar 2007

Installation

Laser diode

• Why is the setpoint power lower than the laser power?
• Laser diode failure (error 05216)

Magnus VLF

• Magnus VLF CR4.1 error: Download of TH3 Firmware Image has Failed
• CB1 trips during Power and SD series with TH3

Tilt

• How to check tilt on a thermal head
• Adjusting Tilt on a Thermal Head
• Checking tilt on a thermal head (Quicktime movie): 14MB, 400x268 resolution
  

  To view this video you must have the latest version of Quicktime installed. Download the latest version.
  

TH2 to TH3 head conversion

Edge detect problems after a TH2 to TH3 conversion

Troubleshooting guides

Chiller Troubleshooting Guide