plate
- Enabling Dolev screen sets in Prinergy
- How can I change the default separation output order in Prinergy Connect?
- Problems running Prinergy after installing Symantec Endpoint Protection version 11 [ID: 82141]
- Characters filled in on high-resolution Prinergy output or at high magnification in Acrobat
- Output from the Adobe PDF Print Engine RIP fails on the Magnus 800 platesetter
- On output, images may occasionally drop off or have lines through them
- Job name in Print Console queue consists of dashes instead of a name; plating stops
- Prinergy jobs using Expose JTP (to Lotem via CS Xpose or Xpo) fail and report error [ID: 78867]
- Prinergy 3.1 variable marks are not populated correctly on output proofs or plates
- PrintLink CIP3 file generation fails, "image width or height not specified"
- Image Control Strip (ICS) looks bad on 2540 dpi device
- Plate exposure fails part way through imaging cycle.
- Render JTP crashes after switching between 3011 and 3016 RIPs
- Plates occasionally missing on output (Prinergy 2.2.1.11 or later and 2.3.1.0 or later using CS Xpose)
- The Magnus or TrendsetterNews platesetter will no longer image two plates at a time when using Prinergy 2.2.1.11 or higher.
- "Treat as flat" does not work with scaled pages
- Job fails plating without imaging, error message "SCSI port is not available" in Prinergy Diagview
- DCS images containing CMYK 0,0,0,0 create "scum dot" on final output, when scaled.
- How do I insert uncalibrated color bars in Prinergy?
- Drive on renderstation fills up with files entitled "(NULL).xx"
- 3016 RIP final output screens all colors at same angle, when using ArtPro Thin PS and OPI Bypass.
- Virtual Proofing System does not match plates when spot color mapping on output
- DigiCap not applied from Final Output Process Plan
- Digicap Keepaway amount wrong on output, Keepaway value changed in PPED, 2nd output sent while first still processing
- DCS images containing CMYK 0,0,0,0 create scum dot on final output, when scaled.
- Proof doesn't match plate when Colormatch JTP is enabled for proof only
- All separations are plated when only some separations are selected for output in Prinergy
- Customer cannot generate plates in Prinergy because of an Edge Detect failure
- Artifacts appear in Copydot images on plate
- Why does my Prinergy-produced plate not look similar to my iMPAct-produced plate?
- Plates are out of register between separations
- Prinergy fails to image a plate with error message: "Image is too large around the drum"
- Cannot plate any Staccato jobs from Prinergy, but AM jobs plate fine: IMAGE ERROR: :34354
- Lotem 400 Quantum punch no longer works after upgrading from Prinergy 2.0 to 2.1.0.8
